ThermalCapture MiniAV – Getting Started
On this page you can find all you need for getting started with our ThermalCapture MiniAV module.
User manual for ThermalCapture MiniAV can be found here.
The module has a 6-pin JST connector. Occupancy of the connector is as follows:
- Video GND
- Analog Video output (NTSC, PAL)
- Serial RX
- Serial TX
- GND
- V-in (3,5V +/- 0,2V)
If the module is in front of you, like in the picture above, Pin 1 is the one on the top.
In order to configure ThermalCapture MiniAV, please connect it to a PC using a USB to serial converter, or our ThermalCapture MiniAV Breakout Board. Then use the configurator to make changes. Available options are described in the user manual PDF.